Align the side in one of the end notches and wrap the mesh around to mark your bend point for the other side. When you have this mark bend the mesh 90 degrees and staple to the other side piece.
Glue and nail one side to one end notch. Wrap and staple the mesh to the end and glue and nail the other side to the opposite notch.
Cut two pieces for the handle ends 1 1/2″X 12″. Round one end.
Drill a 3/4″ hole in the rounded end 3/4″ down from the top.
Cut the 3/4″ dowel to 17 1/2″.
Glue and nail the handle ends flush to the end bottom and centered.
Put the dowel into the holes, glue and nail.

More amazing ideas …